Step 1 of 3 — Add your two files
Put the song from one video
onto your video or photo.
Drop a clip you filmed — or a single photo — and the video (or song) whose audio you want. AudioSwap extracts the music, lays it over your picture, and lets you trim, fade and export. A photo turns into a video that runs for the whole song. No account, no upload, no watermark.
Your video or photo
A clip, or a single photo — JPG, PNG, WebP or HEIC. A photo becomes a still video for the whole song.
Choose Video or PhotoMusic video or song
Only its audio is used. MP4, MOV, MP3, WAV, M4A — all fine.
Choose Music FileAdd both files to continue. Everything is processed on your own device, so keep clips under about 300 MB for a smooth run.
- Nothing is uploaded. The whole conversion runs inside this tab using WebAssembly.
- Photo or video. A single photo becomes a video that runs for the whole song, or any length you set.
- Works offline. Once the page has loaded, you can pull the plug.
Step 2 of 3 — Trim and mix
Editor
Trim your video
Keeping 0:00.0 — from 0:00.0 to 0:00.0Pick where the music starts
Song begins at 0:00.0Length of the finished video
The export will run for the full length of the song from the start point you picked.
Finished video will be 0:00.0 long
Sound mix
At 0% the original audio is removed completely. Raise it to keep voices or ambience under the music.
Export settings
Recommended. Your picture is copied untouched, so a 2-minute clip exports in seconds. The cut snaps to the nearest keyframe, so the start can land up to a second early.
First export loads the video engine (about 32 MB) once. After that it is instant.
Step 3 of 3 — Done
Your video is ready
- File
- —
- Size
- —
- Length
- —
- Took
- —